Котли опалювальні - Частина 5: Опалювальні котли на твердому паливі з ручним і автоматичним завантаженням топки і номінальною теплотворною здатністю до 500 кВт. Термінологія, вимоги, випробування та маркування

Bibliography

1. EN 12619, Stationary source emissions — Determination of the mass concentration of total gaseous organic carbon at low concentrations in flue gases — Continuous flame ionisation detector method

2. EN 13526, Stationary source emissions — Determination of the mass concentration of total gaseous organic carbon in flue gases from solvent using processes — Continuous flame ionisation detector method

3. EN 14789, Stationary source emissions— Determination of volume concentration of oxygen (O₂) — Reference method — Paramagnetism

4. EN 14792, Stationary source emissions— Determination of mass concentration of nitrogen oxides (NO_X) — Reference method: Chemiluminescence

5. EN 15036-1, Heating boilers — Test regulations for airborne noise emissions from heat generators — Part 1: Airborne noise emissions from heat generators

6. EN 15058, Stationary source emissions— Determination of the mass concentration of carbon monoxide (CO) — Reference method: Non-dispersive infrared spectrometry

7. EN 22553, Welded, brazed and soldered joints — Symbolic representation on drawings (ISO 2553)

8. EN 60730-2-9, Automatic electrical controls for household and similar use — Part 2-9: Particular

requirements for temperature sensing controls (IEC 60730-2-9)

9. EN ISO 13919-1, Welding — Electrons and laser beam welded joints — Guidance on quality levels for

imperfections — Part 1: Steel (ISO 13919-1)

10. EN ISO 13919-2, Welding — Electron and laser beam welded joints — Guidance on quality levels for imperfections — Part 2: Aluminium and its weldable alloys (ISO 13919-2)

11. EN ISO 15609-4, Specification and qualification of welding procedures for metallic materials — Welding procedure specification — Part 4: Laser beam welding (ISO 15609-4)

12. EN ISO 15614-11, Specification and qualification of welding procedures for metallic materials — Welding procedure test— Part 11: Electron and laser beam welding (ISO 15614-11)